Prosedur teks bahasa inggris membuat meja

Using paper, pencil and ruler, draw roughly the table design you will make.Sketch the outline form first, regardless of scale.After your outline design drawing is ready, draw the dimensions outline. The dimensions of the table vary greatly depending on the type of table you will make. In other words, the dining table will have a different dimension to the phone table.Consider where the table is when you create the dimensions. You must make it according to the size you need.Using your coarse dimensions, determine the amount of wood you need. Always provide a little more wood, just in case.Buy your wood. Beginning wood craftsmen should choose soft woods such as pine wood. For better finished results, try poplar wood. And if your wooden table will be laid outdoors, consider using redwood or wood that has been processed before.Create a table top. There are two ways to create a table top:Using the board. The advantage of using a board is a cheaper price than a single sheet. The glued-in boards are the easiest to use, but if you can use a nail to make a board holder, then maybe you should try it.Using single sheet of wood. If you choose to use this way, you can save money by using plywood construction.Cut, paste and clamp the top of the table and leave overnight.
Create the bottom of the table. The bottom of the table is a square-shaped wood that lies beneath the top of the table, and helps support the table legs. To create the bottom of the table:Measure a few inches of the inside of the top of the table. The width of the table will definitely vary depending on the dimensions of your table. Mark your position.Turn over the top of the table and draw a square at the bottom as per the sign you made.Cut two pairs of wood for the front and two for the side of the table,Glue and clip the log is parallel to the line you created at the bottom of the table. You may prefer to use screws to hold these parts permanently or to maintain their position until the glue dries, if your clamping size is not able to hold the wood perfectly.Create table legs.Cut one leg according to the size you want. Cut the other three legs of the same size.Pinch all your table legs together. Cut four legs of the same width table while still clamped, use the first leg as a reference. Fine your table legs using wooden sandpaper so that it is smooth and ready to be rearranged to smoother. Be careful when smoothing the top or bottom of the foot of the table, because it can change the angle of the pieces that you have made.Close the legs of the table.Turn the table if it's not in reverse.Put the first leg in the bottom corner of the table with the top right at the bottom of the table, and the sides are parallel to the bottom of the table. Apply glue to the top of the table leg and to the part that is attached right to the side of the bottom of the table. Keep the table leg position by tightening the screw - do not use nails - through the bottom of the table toward the legs. Check your table legs to be in the right angle to the top of the table. Adjust the screw to your needs. Repeat this process on the other legs of the table. Once everything is plugged and flattened, tape and clamp the table legs in place. Once everything is plugged and flattened, tape and clamp the table legs in place. Other options you can put screw into the top of the table legs from the top of the table, but the appearance of the results in this way is often not very good, and you risk splitting the top of the meje's leg by nailing or screwing it to the edge of the wood. Wait until the glue dries perfectly.Turn the table up and notice its position by placing it on the floor and wiggling it. Focus your table to the level you like. Or you can use layers like wood paint, varnish or tung oil.